Cosleeper instruction manual

Position your fingers over the center of the top bar and your thumb on the "Press to Unlock" button. Push the button in, while simultaneously lifting the bar, and push down until the side resembles a "U" shape.

Next, open the two Velcro flaps on both of the nylon side panels, right below the plastic corners. Locate the locking tab inside both upper plastic corner pieces and push toward the center of the playard. Raise the plastic connector up and out of the receiving slot. Insert the connector into the lower slot and push down until the locking tab clicks shut.

Repeat this on the other side of the unit. Grab the center of the top bar and pull up until it clicks and locks. Lock the bottom bars now. Assemble the bar and hanger set; this consists of four hangers, three long bars with metal buttons and two connector bars. Do this by inserting the long bars into the hangers, making sure that the metal button clicks into the plastic hanger. Connect the long bars into the sides of the short bars. Attach the assembled bar and hangers to the co-sleeper bassinet.

Do this by placing the hanger on the nylon bar and rotating it until it is in the correct position instructions for the correct placement of the hangers is located on the unit for your convenience. Remove the liner from the plastic bag and lay it over the co-sleeping frame, the long flap should lay over the lower bar.

Pull the back corners over the co-sleeper frame and secure the liner into place by using the corner snaps. Secure the overhanging liner to the co-sleeper by using the three Velcro patches found on the front and sides of the nylon panel. Install the playard floor as a mattress for the co-sleeper bassinet. Do this by laying the mattress on top of the liner. Then connect the Velcro on the bottom of the mattress to the support bars of the co-sleeper.

Push a Velcro strap down through the slit on the liner. Pull it around the metal support bar, then push the strap back up through the other split in the liner. Secure the Velcro to the mattress. We regret that due to technical challenges caused by new regulations in Europe, we can for the time being no longer accept orders from the European Union. If you reside in the UK you can continue to order from our UK websites or shop from our locations and partners.

Visit West Elm at www. Matters of consumer privacy and rights are paramount to our brands and we will continue to work diligently to make our products available to you. If you have locked the bottom bars first, the locking mechanism in the unit will not allow you to continue locking all the top bars. View Example With your hand or your foot, unlock the front bottom support bar by pulling up on the center of the bar into an upsidedown "V" as high as it can go.

View Example Unlock the top bar by wrapping your hands around the center of the bar and locating the locking mechanism with your thumbs. Push in on the buttons and gently pull up, then push down. By doing this correctly the bar will release into a "U" position. View Example Put your left leg against the lowering bar so that you are standing sideways. Grab the plastic connector with your hand and pull the plastic tab towards you while lifting the connector up at the same time.

View Example Repeat this step on the opposite side. Fasten the snaps and velcro underneath the corners of the plastic connectors and receivers. View Example Attach the connectors into the upper receivers on both sides. View Example Lock the top bar by pulling up on the center of the bar. View Example Once the top bar is locked, lock the bottom support bar by pushing down on the center of the bar.

View Example Fold away the three nylon straps in the front pockets of the unit. View Example The cosleeper is now in bassinet position.